Electrical power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE 1
General Description
This energy unit is designed solely for the tiny lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be extensively employed while in the industry of logistic products for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled through the solenoid valve together with the pace controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is designed exclusively to the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve and also the speed managed by the adjustable needle valve. Once the lift rises to a large positoin, but the power supply is reduce, the lowering movement is managed by the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is created solely for your significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and the pace controlled by a strain compensated movement handle valve.
Electrical power UNITS FOR LIFT TABLE four
Standard Description
This power unit is developed solely for that significant lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve along with the pace controlled by the adjustable needle valve. Once the lift rises to a large positoin, but the energy provide is reduce, the reducing movement is controlled by the guide override function.
Special Notes
1. This energy unit is of S3 duty cycle, which might only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic parts concerned ahead of installation of the electrical power unit.
three. Viscosity in the oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is advisable.
four. Oil altering is required soon after the original 100 operation hrs,afterwards once each and every 3000 hours.
5. The electrical power unit proven is created to be mounted vertically.